Rigol M3TB16 Instrument Options – ACT Terminal Box

$37.00

Category:

Description

 

ACT Terminal Box
M3TB16 ACT Terminal Box
Terminal block for MC3416

Rigol M3TB16 ACT Terminal Box Terminal block for MC3416.Terminal block accessory for M300 DAQ system modules with model numbers ending in 16.Measurement Connections Using
External Terminal BlocksM300 provides 6 kinds of terminal blocks to easily connect the signal to be measured to the module. The models of the terminal blocks and corresponding
modules are listed in the table below. This section introduces how to use the external block. Terminal Block Module 1 M3TB32 MC3132, MC3232 2 M3TB64 MC3164, MC3264 3 M3TB24
MC3324 4 M3TB48 MC3648 5 M3TB16 MC3416 6 M3TB34 MC3534Note: for the MC3724, the signal can be connected to the SMB connectors on the module directly. No terminal block is
needed.WARNING: Cut off all the power supplies before opening the terminal block or removing the terminal block from the module.1.Place the terminal block with the front (with
the RIGOL caption) facing downward and pull the two latches in the arrow direction in the figure below and press them down. Place the terminal block with the front facing upward
and pull the upper cover of the terminal block upward and remove it.2.Connect the cables for connecting the signal under test according to the labels on the circuit board of the
terminal block (for the connecting method, refer to Table 1-1). Pass the binding wires through the two groups of holes as pointed out by the arrows in the figure below to fix
the cable connected. Pay attention to the channel or terminal connected to the cable to ensure that the signal connected is correct.3. Connect the terminal block to the module
via interface 1 (the interface definition is in Figure 1-7) on the module and screw down the two screw rods onto the nuts on the module.4. Close the upper c

Reviews

There are no reviews yet.

Be the first to review “Rigol M3TB16 Instrument Options – ACT Terminal Box”

Your email address will not be published. Required fields are marked *